Restoration

Stock Profiling & Reshaping

A stock reshaped to a new profile: a shotgun buttstock cut and profiled into a pistol grip for a Form 1 build, a comb or wrist slimmed to fit the shooter, a forend or composite stock relieved so a muzzle device or silencer clears. Shaped by hand, blended so it looks factory, and refinished to match.

Reshaping, on wood and synthetic

Profiling is the part of stock work where the shape itself changes. The job that comes in most is the short-barreled shotgun: an approved Form 1 in hand, the barrel chopped on the gunsmithing side, and the buttstock profiled down to a pistol grip — cut, shaped, the grip cap fitted, and the whole thing refinished so it reads as a design, not an amputation. A Savage 420 that came in as a long double left as a correct SBS with a pistol grip and a fresh finish.

The rest is fit. A comb lowered or raised so your eye lands on the rib, a wrist or a thick factory grip slimmed to your hand, a forend or a composite stock relieved to clear a brake or a can that the factory never planned for — we did that under warranty on a threaded rifle whose chassis wouldn't take the muzzle device. Wood, laminate, polymer, and composite all shape; each wants a different tool and a different finish, and the shop has them.

Shaped to fit you, finished to match

Reshaping without refinishing leaves a scar, so the two go together: the reshaped area is blended into the surrounding surface and finished to match the rest of the stock, whether that's oil on walnut, texture on polymer, or a coating over composite. Bring the gun and we'll measure you to it — comb height, length of pull, cast — before anything is cut, so the new shape is the right one the first time.

How a profiling job runs here

01

Measure and draw

The new profile is drawn on the stock from your measurements or your Form 1 build plan, and agreed before the first cut.

02

Cut and shape

Rough cut, then shaped by hand with rasps, files, and sanding blocks — or the right abrasives for polymer — and test-fitted to you as it goes.

03

Blend and finish

The reshaped area is blended into the original surface and refinished to match, with a grip cap or pad fitted where the profile needs one.

Answers

Common questions

Can you turn my shotgun stock into a pistol grip?

Yes, on an approved Form 1 for a short-barreled shotgun, or on a shotgun that stays legal length. We'll cut the barrel, profile the stock, fit the grip cap, engrave the NFA markings, and refinish it, all on one ticket. A recent one — barrel chop, stock profiled to a pistol grip, and the refit — ran $160 to $180 in stock work plus the barrel and engraving.

Can a composite or polymer stock be reshaped?

Yes. Polymer and composite shape with different tools than wood and take a different finish afterward — texture restored on polymer, a coating on composite — but relieving a stock for a muzzle device or slimming a grip is routine on both.

Bring us the project.

Start an NFA transfer, ask about a service, or send photos for an estimate. We answer fast.

Get started